When "shingle roofs - such as" search for information, you are exactly right. The trend towards thicker tiles makes the job of cutting them a little 'more difficult. Here are three tools that will do the job ...
Shingle roofs: How to cut the tiles - Tool # 1 Utility Knife
Go with a model that can quickly change blades without tools. They also receive a fixed blade knife with a retractable mechanism that locks covered with tar. And you want one thatfits naturally in your hand during the presentation of the blade at an angle to work efficiently. The best utility knife I found in the roof, is a model of Stanley 10-399.
Blades straight cut on the back of the shingle and hook blades cut on his forehead. So you should really two knives in your tool belt. Keep you're ready to jump with a straight blade and you're ready, with a hooked blade. This saves a lot of time switching back and forth between the blades.
Also keep some 'of bothBlades in each blade. So if (this is easy to do) you can put the knife to get through with a knife.
Shingle roofs: How to cut the tiles - Tool # 2 Shears
Shears work surprisingly well for cutting shingles. They are easy to operate faster and easier than a knife for cutting around pipes and valves. They also work great for cutting shingle valleys.
The only problem is ... dark tiles are hard edge. As such, it can leadI will cut the brand new shingles. But if they become too boring for the metal, I replace it and recycle the old and the shingles.
Although many "Tinners" special scissors for cutting right and left. I found that Wiss M3R Straight Cut (yellow handle) cut good job for most all my work in metal ... and the tiles.
Shingle roofs: How to cut the tiles - Shear Tool # 3
This is a tool that you do not use all the time, but it makes the cutting short of herpes zoster.It seems like a guillotine cutter, except that it is serious. It can be easily used to cut each tile to almost every corner.
But it seems very straight cut. Suppose fitting of shingles along a side wall ... The scissors cut the gravel and simply place the exact length you need.
I also used to save pieces of gravel on the sides and in the valleys, which cut the wrong place at the end. The gap quickly squares up to the end just for you from a "factory finish" toit. And 'much faster than a knife and does a better job.
There are two or three models on the market, but my preference is the "cut pebbles" of instruments made by Howard.
No comments:
Post a Comment